Video: How safety airbags works
clip 1; clip 2; clip 3; clip 4
Design
• The default"half-back"design provides full protection on the front (backrest, bolster, cushion part) while maintaining access to original pockets behind the backrest (if any) by covering only the top section behind the backrest.
"Full-back"option means behind the backrest is full-length covered.
"Map pockets"option means pockets can be added to both passenger and driver sides.
• The default rear design allows for split-fold seats (i.e in separate covers), but normally covers up the armrest/cup holder (if any), making it inoperable. To access it, zipped armrest cut-out can be made on request.
The armrest itself is not covered in most models as the thickness of material would make a cover too bulky to push back into the recess in the seat.
Highly durable material
Our exclusive automotive-grade premium neoprene (wetsuit) material is used for manufacturing seat covers for car companies, importers dealerships in Australia. It is 2.4-2.5 mm thich, UV stabilized, fade and abrasion resistant. The top layer is synthetic fabric very comfy to sit on, the backing layer is of soft rubber that grips to the seat and will not slide around when sitting on it.
Snug fit
Tailor-made cover tightly shapes around the curves of the seat with no ties or straps needed. It grips to the seat and won't slide around, effectively protecting the original fabric/leather seats.
Easy installation and maintenance
No tool is required to install, simply follow easy steps in the fitting instructions. Recommended hand wash in normal cold water with mild detergent and then air dry
Side-mounted airbag compatible
Safe airbag deployment is achieved with the "split-open" airbag seam sewing technique, which is test certified by an Australian accredited test agency.
Colour
Charcoal black fabric with default light grey stitching. Other stitching colour options cost extra. |
